Best quality Automatic Flood Prevention - Surface type Automatic flood barrier for Metro – JunLi

Short Description:

Product Detail

FAQ

Product Tags

Feedback (2)

Our business puts emphasis over the administration, the introduction of talented staff, plus the construction of team building, attempting hard to boost the standard and liability consciousness of personnel customers. Our corporation successfully attained IS9001 Certification and European CE Certification of Aluminum Flood Prevention Barrier , Automatic Flood Defence , Type Flood Gate Used For The Garage Home , We are looking forward to building positive and beneficial links with the companies around the world. We warmly welcome you to contact us to begin discussions on how we can bring this into being.

Best quality Automatic Flood Prevention - Surface type Automatic flood barrier for Metro – JunLi Detail:

Model	water retaining height	Installation mode	bearing capacity
Hm4d-0006E	620	surface mounted	(pedestrian only)metro type

Scope of application

Grade	Mark	Bearing capacity (KN)	Applicable occasions
Metro type	E	7.5	Metro entrance and exit.

The Model Hm4d-0006E hydrodynamic automatic flood barrier is applicable to the entrance and exit of subway or metro train stations where allow for pedestrian only.

(1) Surface installation location

a ) It is about 5cm high from the ground. Need to prevent it from scratching the vehicle bottom when the vehicle is fully loaded. When the car is fully loaded, the minimum ground clearance: Pentium B70 = 95mm, Honda Accord = 100mm, Feidu = 105mm, etc.

b) )The location should be on the horizontal section at the top of the ramp, the inside of the outermost intercepting ditch, or installed on the intercepting ditch. Reasons: small water can be discharged through intercepting ditch; it can prevent backflow from intercepting ditch after municipal pipeline is full.

c)The higher the installation location, the higher the water retaining level.

(1) The levelness of the installation surface

a) The installation surface horizontal height difference at the end of the wall on both sides ≤ 30mm (measured by laser level meter)

(2) The flatness of the installation surface

a) According to code for acceptance of construction quality of building ground engineering (GB 50209-2010), the surface flatness deviation shall be ≤ 2mm (measured with 2m guiding rule and wedge feeler gauge), otherwise, the ground shall be leveled first, or the bottom frame will leak after installation.

b) In particular, the ground with anti-skid treatment shall be leveled first.

Product detail pictures:

Related Product Guide:

We normally think and practice corresponding on the change of circumstance, and grow up. We aim at the achievement of a richer mind and body and also the living for Best quality Automatic Flood Prevention - Surface type Automatic flood barrier for Metro – JunLi, The product will supply to all over the world, such as: Liverpool , US , Canberra , Good quality and reasonable price are our business principles. If you are interested in our products or have any questions, make sure you feel free to contact us. We hope to establish cooperative relationships with you in the near future.